Forumradioamatori.it
Modifiche - Forumradioamatori.it non è in alcun modo responsabile di eventuali danni subiti, se non sei sicuro di quello che fai lascia perdere e basta!!! => ICOM => Discussione aperta da: francesco calanna il Mer 20 Novembre, 14:51 2013
Salve sono il possessore dell' ic-e208 volevo sapere se si può incrementare la banda di ricezione oltre i limiti impostati e se è possibile la eventuale procedura. Grazie
Ciao, in giro si trova la modifica per l'IC-208H ma credo sia la stessa cosa, a seguire ti invio la modifica, in pratica bisogna rimuovere (o tagliare) due resistenze https://amzn.to/448Hiuh e poi successivamente effettuare il reset tramite la combinazione di tasti, e il gioco è fatto!
Icom IC-208H Expanded RX-TX
1. Place the radio with the front panel toward you and bottom side / speaker side UP.
2. Remove the (4) screws located in each corner.
3. CAREFUL! Go slow, you will need to disconnect the speaker cable while removing the cover
Look at the lower right hand corner of the main printed circuit board.
4. You should see a silver crystal with the number "D196D3C" printed on it.
5. Just above the crystal, you should see an (8x8) matrix pad (see below pic).
6. REMOVE BOTH RESISTORS [Do NOT attempt this unless you know how to use a low wattage soldering iron]
7. RESET THE RADIO, hold the [SET LOCK] and [S.MW-MW] buttonsdown during power-up.
DONE! New RX/TX Ranges:
118.0000 - 135.9875 RX-AM only
136.0000 - 173.9875 RX & TX (15% RF power fall-off at lower freq, Full power at high freq)
230.0000 - 399.9875 RX only
400.0000 - 478.9875 RX & TX (Do NOT transmit below 410MHz on HI-PWR, VSWR fold-back)
479.0000 - 549.9875 RX only
810.0000 - 849.0000 RX only
849.0000 - 869.0000 RX only
894.0000 - 999.9875 RX only