Modifica espansione di banda per Kenwood TH-78A

Aperto da RADIOMOD, Lun 07 Gennaio, 19:09 2013

Discussione precedente - Discussione successiva

0 Utenti e 2 Visitatori stanno visualizzando questa discussione.

Senza nome 1

"In qualità di Affiliato Amazon io ricevo un guadagno dagli acquisti idonei" (Disclaimer)

RADIOMOD

                                 Kenwood TH-78A

This mod will open uo the 300 and 800MHZ receive frequency range/b]


1) Disconnect the antenna and battery
2) Remove 4 screws, 3 on the back and 1 on the left side
   and open the case.
3) Locate the PC area covered by a brass shield in the front half of
   the radio.  Along the edge you will see a row of 6 diodes vertically
   on the PC board.  Newer units have two jumper wires extending from
   the same area in the area around D4 and D5.
4) If you have a newer unit with the two jumpers cut both jumpers in half.
   On the older units without the jumpers you must remove diodes D4 and D5.
   Removing D4 or the jumper in series with D4 will allow cross band
   operation.  Doing the same with D5 will enable the expanded RF range.
5) If you need to remove the diodes be careful not to damage the other
   circuits and if you removed the brass shield replace it making sure
   nothing else is shorted out.
6) Reassemble the radio and be careful of the small O-rings sealing the
   two LED's.
7) Reset the radio's microprocessor, see user manual.

8 To select the 300 & 800MHZ ranges  press [F] key for 2 seconds the
   the [BAND].  To turn ON/OFF the cross band repeater function press F and 0.

-

Prodotti interessanti da acquistare

Sezione articoli utili da avere

 

free countersfree countersfree counters