Forumradioamatori.it
Modifiche - Forumradioamatori.it non è in alcun modo responsabile di eventuali danni subiti, se non sei sicuro di quello che fai lascia perdere e basta!!! => ICOM => Discussione aperta da: RADIOMOD il Ven 04 Gennaio, 21:41 2013
ICOM IC-æ2AT
Expanded RF
1- Remove battery and antenna.
2- Remove 4 screws and open the radio.
3- Separate shield & top circuit board from bottom board.
4- Locate micriprocessor board.
5- Tack solder a 1N914 diode across Pin 20 & 27.
or attach a chip diode 1SS196 as shown.
6- Reassemble the radio.
7- Reset the microprocessor (push and hold lamp and turn the power ON.
NOTE: This diode is placed across pin 20 & 27 of CPU. Drawing is not to Scale.
MICROPROCESSOR is under the pad (under shield).