Modifica espansione di banda per KENWOOD TH-45

Aperto da RADIOMOD, Lun 07 Gennaio, 14:48 2013

Discussione precedente - Discussione successiva

0 Utenti e 1 Visitatore stanno visualizzando questa discussione.

Senza nome 1

"In qualità di Affiliato Amazon io ricevo un guadagno dagli acquisti idonei" (Disclaimer)

RADIOMOD

KENWOOD TH-45
                                     
EXPANDED RF



1- DISCONNECT POWER AND ANTENNA.
2- Remove the volume. squelch and tuning control knobs.
3- Remove the nuts from the volume control and tuning controls
4- Remove the screws located by the PTT switch.
5- Remove the screws by the speaker jack.
6- Remove the screws from the battery plate.
7- Carefully pull the front panel from the radio. Do not break any wires.
8- Gently lift the top panel from the radio by pulling it forward and then
Upwards. The O ring on the BNC connector will cause same tension.
9- Rotate the top the panel towards the front of the radio to expose the
.75" x .75" board.
10- Remove chip resistor R-18 and R-28.
11- Reset the radio
12- Reset the CPU (hold down [M] and turn the power ON.

-

Prodotti interessanti da acquistare

Sezione articoli utili da avere

 

free countersfree countersfree counters